|
NOTES
|
✎
You can control the intensity of the effect
with the FOLDER -, + button.
✎
To cancel an effect, press the effect's button
again.
✎
You can also control the effect using the
EFFECT -, + button on the remote control.
✎
Use the FOLDER -, + button to control the
intensity of the effect that was activated
last. For example, if you activated the
WahWah effect and then the Panning
effect, the FOLDER -, + button will control
the Panning effect.
✎
To control the intensity of the effect you
applied first, press the button of effect that
you applied last to turn it off. Then, you can
use the FOLDER -, + button to control the
intensity of the first effect.
+PANNING Function
Increases the left and right speaker's output
in turn and makes it seem as if the sound is
moving from side to side.
|
NOTE
|
✎
To apply the PANNING effect to another
effect, press the +PANNING button when
the other effect is active or press another
effect button when the PANNING effect is
active.
NON-STOP MUSIC RELAY Function
The NON-STOP MUSIC RELAY function
plays music continuously without an interval
between tracks/files. If there were two mp3
files, it skips to the next file’s 10 seconds from
the start position when the previous track
reaches its 10 seconds before the end position.
Press the NON-STOP MUSIC RELAY button on
the main unit or NON-STOP RELAY button on
the remote control.
Each time you press this button, the mode
changes as follows:
NON-STOP RELAY ON
;
NON-STOP RELAY
OFF
|
NOTE
|
✎
This function is only available during the
playback of a CD/USB.
TEMPO Function
Use this to change the TEMPO of the music
while music is playing.
1. During playback (CD-DA/MP3/WMA),
press the TEMPO button on the remote
control or on the main unit.
2. Select the desired TEMPO by using the
EFFECT -, + button on the remote control
or VOLUME/SEARCH JOG on the main
unit.
|
NOTES
|
✎
You can set each of the TEMPO functions
from -10 to +10. The initial setting for all
functions is 0.
✎
The TEMPO Function does not operate in
the Bluetooth, TV SoundConnect, TUNER
and AUX mode.
✎
When you turn TEMPO off, all TEMPO
settings are lost.
PARTY BEAT Function
The PARTY BEAT function lets you make
percussion sound effects by tapping the Party
Beat pads on the top of the Hi-Fi Component
with your hands. You can adjust the percussion
dynamics to provide realistic sound effects.
1. Press the PARTY BEAT button on the main
unit to toggle PARTY BEAT ON or PARTY
BEAT OFF.
The display panel shows the current PARTY
BEAT status.
2. Select the percussion sound by pressing
the PARTY SOUND▶ or PARTY SOUND◀
button while PARTY BEAT is set to PARTY
BEAT ON.
28 English
[MX-JS9500-ZA]AH68-02851A-00ENG.indd 28 2015-04-14 오후 1:37:43
To Next Page
Loading...
