175
Q
When I connect a projector, and
change the setting to display
screen image on both the LCD
and the projector by pressing Fn
+ keys, screen is not displayed
properly.
A Press Fn + keys once again. If the
same problem continues, it means
the projector cannot support the
resolution. Lower the resolution to 800
x 600.
Q
The Taskbar on the bottom of the
screen does not appear when a
projector is used as the display
device.
A This may happen, if the projector
does not support LCD resolution. In
this case change the resolution to
800 x 600 (recommended) on your
computer.
Q
Switching the MS-DOS command
prompt to full screen mode or
Windows mode by pressing the
<Alt>+<Enter> keys does not
operate properly.
A Pressing the <Alt>+<Enter> keys
using an USB keyboard, may cause
the key input to be recognized as
multiple key inputs depending on the
keyboard input recognition time. In
this case, the MS-DOS command
prompt is repeatedly switched to
full screen and then to Windows
several times. Please press the
<Alt>+<Enter> keys more quickly, or
press the <Alt>+<Enter> keys using
the system keyboard.
Q
The shortcut icons are not
displayed on the screen even if I
press the shortcut key.
A The shortcut icons only appear when
the Easy Display Manager program is
installed.
To Next Page
