4. Disassembly and Assembly
4-35. Assembling Procedures of the CO2 Cylinder and Precautions
To do list
4. Lock the Cylinder into place by pressing the Lever.
• The inner pressure of the Cylinder may make it difficult to press the lever down.
Hold the lever as shown in the illustration on the right, and then push down.
• If you don’t lock the cylinder into place, the refrigerator won’t produce sparkling
water.
• If the cylinder is not tightly connected to the Regulator, it will leak CO2 gas,
producing a hiss. If this occurs, repeat Steps 2, 3, and 4, making sure that the
cylinder is firmly attached and locked into place.
5. Press the Sparkling Water button 3 seconds for Cylinder Reset function. Wait bout
20 minutes. (the amount of time needed for a medium level of carbonation) while
the refrigerator makes sparkling water.
• To make sparkling water, the refrigerator injects CO2 from the CO2 cylinder into
water stored in the Sparkling Water tank. The water enters the tank through the
refrigerator’s water supply line.
6. To remove any residual substances that may be in the water, dispense 2 or 3 large
glass fulls of Sparkling Water and empty them into a sink.
114
For more information about using the Sparkling Water function, see Using the Sparkling Water Function.
To Next Page
Loading...
Need help?
General
