Samsung RS261M - Page 40

- 40/47 -
Tip 9-1-1. Inspect self-diagnosis test
 Inspect Ice Maker
Block
① Disassemble F Ice Maker Screw top
② Inspect Top Wire Harness contact.
※ Water doesn’t come even ice maker operates Test,
TIP 2-2
※ If there is no problem on water supply problem
and Test, TIP 2-5
Circuit diagram ① When the Sensor is failure
: inspect no.5(WHI) +
no.6(WHI)
② When the Sensor is normal시
: Ice Maker bottom Test
button
※ Press for 2sec
③ Check ice maker operation
※Replace ice maker after inspect
Twist problem Wire
Main PBA ① When Sensor is failure “CN
90”
:Inspect No. 5(WHI) + 6(WHI)
② When the Ice Maker Test
operation is failure inspect
“CN 90”
- Rotate operation:
1(RED)=2(BLK)
- Output sensing: 5(BLU)
- Test input: 4(S/BLU)
Sensor
Test
button
Connector
CN 90
Motor Twist
Water supply