Connecting the Power Source
ENGLISH
22
✤ There are two ways to connect power source.
- Using the AC Power Adapter : used for indoor recording.
- Using the Battery Pack: used for outdoor recording.
To use AC Power Adapter
1. Connect the AC Power Adapter to the AC cord.
2. Connect the AC cord to a wall socket.
Note: The plug and wall socket type may be different depend-
ing on regional conditions.
3. Connect the other end of the DC cable to DC jack of the cam-
corder.
4. To set the camcorder to the CAMERA mode.
a. Hold down the tab of the power switch and push the switch
to CAMERAmode.
b. Set LOCK/STANDBY switch to STANDBY.
c. Make sure that the Lens Cap is open.
d. Open the LCD monitor and make sure that the image
appears in the LCD monitor.
- The LCD monitor is turned on automatically when it’s
opened more than 30 degrees.
Note: If the adapter is used next to a TV or the camcorder, it may
cause the TV or camcorder to emit noise. Move the adapter away from the TV, camcorder or the
antenna cable.
1
2
3
4-a
4-b
CAMERA
STANDBY
To Next Page
Loading...
