4. Connect Cables & Camera Setup
Connect each camera cable to the proper
terminals on the bottom of the camera (Refer to
Page 13: “Camera Wiring Diagram”). Configure
the DIP switches on the bottom of the camera for
communication and ID (Refer to Page 16).
3. Detach the Mount Housing
Remove the 3 screws, and then detach the mount housing from the camera.
Installing Your Camera
5. Install Camera
Install Camera Fit the camera to the hole on the ceiling, and then secure the camera
using 3 Product-enclosed Fixture Screws (M4x20).
6. Assemble Dome Cover
Assemble Dome Cover Insert the grooves on the dome cover into ones on the
camera, and then turn clockwise to fasten.
Screw
Screw
Ceiling
Ceiling
To Next Page
Loading...
