Samsung SCP-2120 - Initialization and Security

SPEED DOME CAMERA User Guide
76
SPEED DOME CAMERA User Guide
77
Functional Description
AUX Output menu is to operate the camera’s peripheral devices such as lamps and sirens through
the controller and switches as well as through network communications.
⇨
NO
COM
AUX Off
NO
COM
AUX On
•ConnectingthepowerconnectorandGNDincorrectlytotheAuxterminal’sNOandCOM
ports may cause a short circuit and fire, damaging the camera.
•Themaximumpower capacityofthebuilt-in relayis30VDC/2A,125VAC/0.5A,and
250VAC/0.25A. Operating the camera beyond the capacity may decrease the camera’s
lifespan and damage it.
Notes
OUT Off 1,2 :
 - When an alarm event occurs, the output force can be terminated.
30. Initialization Menu
 ▶
Main Menu/Initialize
Power On Reset
:
Restarts the camera.
Factory Default
:
Enables resetting the camera to its factory default settings.
When the mode is selected, all custom data such as preset
locations is deleted from the camera.
Use this function if it is necessary to reset the settings of
the camera.
Camera Default
:
Resets the camera zoom module to the Factory Default
mode; use if you want to reset all camera settings including
Exposure and Backlight.
Auto Refresh
:
Enables optimizing the status of the camera’s built-in
electric circuits and components on a regular basis. (A
regular operation can be scheduled.)
This mode can be used to maintain and repair the current
settings of the camera when anomalous operations occur:
e.g. The camera happened to directly face a light source, or
the settings have been canceled after the camera
repeatedly rotated in all four directions for a long time to
monitor a specific location.
The default setting is Off.
- Off, 1~7 Days : Selecting Off disables Auto Refresh and
selecting 1~7 Days automatically executes it after 1~7
days has passed.
✽ Auto Refresh takes approximately 10 seconds to finish. If
Auto Refresh activates in the middle of a sequence action,
the camera pauses the sequence action and performs an
Auto Refresh, then resumes the sequence action once the
refresh is complete.
➡
Initialize
Initialize
Power On Reset
Factory Default Set
Camera Default Set
Auto Refresh OFF
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Password Setting
Status