• Preset Number Setting Screen :
ID=001 ①②
Area1 Area Name
G-SEQ1
PRESET=001 Preset Name
P:300 T:040 10X
Motion Detect
Alarm Input
Preset Info
Sequence Status
• Motion Detection Standby/Operation Display :
- When in standby mode, the " " in the upper right of the screen blinks and then
changes to " " if motion is detected.
• Alarm Input Port Status Display :
- "①","②" in the upper right of the screen blink.
• Current Alarm Port Display According to Input Alarm Ports(Priority) :
- Only one of " "," " in the upper right of the screen blinks.
• Preset Number Display Settings :
- '*' : If a preset number is already available
- 'H' : If a preset location is the camera’s home position
• If an OSD Menu has Sub Menus :
- " " displays at the end of the menu.
• If an OSD Menu Does Not Have Sub Menus :
- No symbol appears at the end of the menu.
• PTZ Function Screen :
Area Display
Preset Edit
Preset=011* (1~255)
Interface Symbols
• OSD Menu Screen :
Camera Setting
Focus & Zoom
White Balance ATW
---
---
Sub Menu Available
Sub Menu Not Available
Command Function
Move the joystick up/down/left/right Moves the OSD menus up/down/left/right, respectively.
Enter/Focus Far Selects a menu and allows access to the sub menus.
ESC/Focus Near Cancels a command and moves back to an upper-level menu.
• Panning and Tilting
- Use the joystick of the controller or its direction buttons.
• Controlling Zoom
- Move the joystick clockwise (Tele) or counterclockwise (Wide), or use the zoom
buttons.
• Accessing Screen Menus
- Press the Menu or OSD button on the controller.
This dome camera can be operated using two methods: Using hot keys on its dedicated
controller, or accessing the OSD (On Screen Display) on the video output. The OSD menu
commands are as follows:
OSD Commands, Function Chart, and Menu Controls
Operating Your Camera
✽
For more detailed information about controls using a third party controller or a DVR, refer to the
user’s manual of the product.
To Next Page
Loading...
