Installing Your Camera
5.
Connect Cables
Connect each camera cable to the proper terminals on the bottom of the camera. For
more detailed instructions, please refer to Page 13:“Camera Wiring Diagram”.
6.
Camera DIP Switch Setup
DIP switches for communication and ID setup are located on the bottom of the
camera. For more instructions, please refer to Page 16.
Flush Mount Type Installation Example
1. Drill Hole on the Ceiling
Attach the template, and then drill a hole
according to the 120 mm diameter hole
marked on the template. Drop down the
camera cables through the hole. Drill
another small hole for a screw to secure
the camera.
2. Exiting Camera OSD
Rotate the dome cover counterclockwise to
detach it from the camera.
To Next Page
Loading...
