English - 33
● CONNECTION & INSTALLATION
INSTALLATION
Fixing the installation base to the bracket
Fix the base with the bracket by turning it clockwise.
Hold the bottom latch of the installation base and gently press it down as shown.
Please refer to the “Camera Wiring Interface Board” on page 12,
connect the wires.
Do not connect the camera to a power outlet until the installation is complete.
Supplying power while the installation is in progress may cause fi re or damage
the product.
Never use installation base for previous models (for SCP-2370/3370 and
SPU-3750T/3700 models) with this product, it is not compatible with this
product. Otherwise, applying power may lead to short circuit and result in fi re or
damage to the product.
Connect the camera safety wire to the installation
base.
❖
1.
2.
J
3.
Knob
Safety Cable
To Next Page
Loading...
