Samsung SCP-2370RH - Alarm Setting

66_
setup
setup
Alarm Setting
Alarm Enable OFF
Alarm Input
Alarm/AUX Output
MD Dwell Time OFF
ALM Dwell Time
HOLD
ALARM SETTING
Alarm Enable
ON/OFF :
Enables or disables the Alarm function.
Alarm Input
MOD
Enables selecting an Alarm Input method.
- NO (Normally Open)
Ä
IN 1.2.3.....8 IN 1.2.3.....8
ALM GND
ALARM ON
ALM GND
ALARM OFF
- NC (Normally Closed)
Ä
IN 1.2.3.....8IN 1.2.3.....8
ALM GND
ALARM OFF
ALM GND
ALARM ON
As shown in the picture above, the Alarm Input must be entered with the Open or Closed switch signals. Supplying power without entering
the signals may damage the product.
z
z
M

< Alarm input when N.O. is enabled >
< Alarm input when N.C. is enabled >
ALM MOD P SEQ. NO
IN1 OFF 1 OFF
IN2 OFF 2 OFF
IN3 OFF 3 OFF
.....
Æ
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
IR Illuminator
Initialize
Password Setting
Status
Æ
When selecting the Camera Name and Preset Name, the screen displays the Left
keypad.
Names can be up to 12 characters and can be entered via the joystick and the Enter
key. Once a name is entered, use the joystick and the Enter key to perform the Set
command and save the name.
M


XXX Name [ ]
"#$%&'()*+,-.
/0123456789:;
BCDEFGHIJKLMN
OPQRSTUVWXYZ[
  
 < >    Â 
BACK SPACE CLR SET