setup
46_
setup
Day & Night
The Day & Night function allows the camera to switch between the
Color and B/W modes.
MODE
AUTO : Operates in Color mode most times, and switches
to B/W mode if a low light level is detected during
nighttime.
COLOR : Operates in Color mode at all times.
B/W : Operates in B/W mode at all times. By using the Burst
On/Off sub menu, burst signals can be retained or
disabled.
Ú
If the camera is in B/W mode and connected to equipment
that requires external sync through burst signals, set the Burst
On/Off option to “On”.
Duration :
The camera’s light sensitivity is adjustable as in the chart
below. The camera’s ambient light diversion performance
may vary depending on its environment.
Color
p
B/W B/W
p
Color
FAST 2.6Lux 4.2Lux
SLOW 1.2Lux 6.0Lux
Dwell Time :
The duration of both the lighting conditions can be customized to
let the camera divert between the daytime and nighttime settings.
Auto mode is not available if AGC is set to OFF or MANUAL.
Using B/W mode under sunlight or a halogen lamp may decrease the focusing performance.
As long as the indicator of the IR light turns on, the camera will be set to B/W mode automatically.
If the IR light is set to Day/Night mode, the mode will switch to Auto automatically.
If the IR illuminator is set to SENSOR or TIMED, it will switch to Day or Night mode depending on the sensor or time.
z
-
-
-
z
-
z
-
M
Camera Setting
Zoom/Focus
White Balance ATW
Exposure
Back Light OFF
AGC HIGH
SSNR MEDIUM
SSDR
Day & Night
Others
Day/Night
Mode AUTO
Duration SLOW
Dwell Time 05 SEC
Æ
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
IR Illuminator
Initialize
Password Setting
Status
Æ
To Next Page
Loading...
