Samsung SIR-4260V - Special Camera Features: Privacy, Communication, and Exit; Privacy Masking and Communication Settings; Exit and Reset Options

COLOR DOME CAMERA User’s Manual
30
COLOR DOME CAMERA User’s Manual
31
Select a desired EXIT mode using the Function Setup switch.
- SAVE : Save the current settings and exit the MAIN SETUP menu.
- NOT SAVE : Do not save the current settings and exit the MAIN SETUP menu.
- RESET : Resets the camera settings to the factory defaults. Language and Monitor settings are not
initialized.
EXIT
COMMADJ(CommunicationAdjustment):
This function sets up the camera communication status when controlling the camera
through an external control device.
 1)  When the SPECIAL menu screen is displayed, press the
FunctionSetupswitchsothatthearrowindicates
‘COMM ADJ’.
 2) SetupthemodeusingtheFunctionSetupwitch.
- CAM ID : Determines the camera's identification
number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/
38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for
the parity bits.
- RET PKT : Determines whether to send a command back to the controller device when a
communication control command is sent to the camera.
- DISP CAM ID : Display camera title on top left corner of the screen.
- Protocol : Select the communication PROTOCOL.
(STW(SPD)/PELCO-D/PELCO-P/BOSCH/HONEYWELL/VICON/SEC/PANASONIC)
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
* Initial value of communication adjustment
Item
Camera ID BAUD RATE UART MODE PET PKT
Initial value
1 9600 8-NONE-1 ENABLE

LANGUAGE :Youcanselectthemenulanguageaccordingtoyourrequirements.

RETURN :SelectthistosavetheSPECIALmenusettingsandreturntotheMAIN
SETUP menu.
• As the DIS function uses the digital zoom the camera's resolution will decrease.
• DIS doesn’t operate when background illumination is too low.
• DIS doesn’t operate when object pattern is monotonic as like sky or white wall.
Notes

DIS(DigitalImageStabilizer):
This function mitigates any picture movement due to external factors such as wind.
PRIVACY : Mask an area you want to hide on the screen.
PRIVACY AREA SETUP
1. AREA AREA1
2. MODE OFF
3. MASK COLOR GREEN
4. MASK TONE 1
5. TOP 39
6. BOTTOM 79
7. LEFT 13
8. RIGHT 52
9. RETURN
1) WhentheSPECIALmenuscreenisdisplayed,presstheFunctionSetupswitchsothatthe
arrow indicates ‘PRIVACY’.
 2) SetupthemodeusingtheFunctionSetupswitch.
- AREA : You can select up to 12 PRIVACY areas.
- MODE : Determines whether to use the area selected in the AREA.
- MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White, Gray.
- MASK TONE : Adjust the brightness of MASK COLOR.
- TOP/BOTTOM/LEFT/RIGHT : Adjust the size and position of the selected area.
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
Operating Your Camera