Samsung SIR-4260V - Connection and Initial Setup; Lens Adjustment and Connection to Monitor; Power Connection Requirements

COLOR DOME CAMERA User’s Manual
12
COLOR DOME CAMERA User’s Manual
13
1)Unlockthezoom(focus)handlebyturninganti-clockwise.
2)Adjustthezoom(focus)bymovingthehandletoWIDE(NEAR)orTELE(FAR).
3)Afteradjustment,tightenthezoom(orthefocus)handle,takingcarethattheadjusted
position does not change.
ZoomHandle
FocusHandle
Installation
Adjusting varifocal lens zoom and focus
Connection
Connecting to Monitor
CCTVCamera
Intermediate
Endmonitor
Monitor
CCTVCamera
Please connect the video output terminal located on the back of the camera to the monitor.
•Theconnectionmethodvariesdependingonthetypeofmonitorandaccessories.Please
refer to the user's manual for each instrument.
•Pleaseturnoffthepowerwhenconnecting.
•PleaseselectHi-Zonthe75Ω/Hi-ZswitchfortheintermediatevideoTVsetandselect
75ΩfortheIntermediatedeviceasshowninthepicturebelow.
Connecting to Power
The recommended adaptor specification for
SIR-4260V is DC 12V/4A.
Please check the standard power requirement
before connecting the power.
•Thereforehavinganexcessivelylongdistancebetweenthepoweradaptorandthe
camera may affect the camera’s performance.
Standardvoltageforcameraoperation:DC12V±10%,AC24V±10%
 There may be some deviation in voltage drop depending on the type of wire and the
manufacturer.
 ThesetforAmericadoesnotincludethepoweradapter.
Whentheresistancevalueofcopperwireisat[20°C(68°F)]
• Please use a power adapter that meets the required standards.
• Please connect the power after installation.
Notes
Copperwiresize(AWG)
#24(0.22㎟) #22(0.33㎟) #20(0.52㎟) #18(0.83㎟)
Resistancevalue(Ω/m)
0.078 0.050 0.030 0.018
Voltagedrop(V/m)
0.028 0.018 0.011 0.006