Samsung SIR-4260V - Communication Connectivity; RS-485 Communication Setup; Coaxial Communication and Video Cabling

COLOR DOME CAMERA User’s Manual
14
COLOR DOME CAMERA User’s Manual
15
RS-485 communication control
UsingRS-485communicationwillenableyoutocontroltheOSDmenufromaSAMSUNG
TECHWINSystemControllerorDVR.
(1)ConnectiontoaPC.
Connect the camera to the PC via a RS-485 converter using RS-485 and a serial cable.
EX) SERIAL PORT OF THE PC(COM1) → SERIAL CABLE → RS-485 CONVERTER → RS-485
CONTROL CABLE
Connecting to RS-485 Control Cable
CONTROL CABLE SPEC
WHITE (TRX+) RS-485+
BLCAK (TRX-) RS-485-
Connection
• When making a control system to control the camera, please use to the STW(SPD)
PROTOCOL or PELCO-P, PELCO-D, VICON, PANASONIC, BOSCH, HONEYWELL, SEC
PROTOCOL.
• When you connecting to RS-485 control cable, please peel off the outer skin inside the
RS-485 control cable.
• In case of SCC-101 connection, change communication mode to 8-E-1 at
 Communication configuration  menu. (For more information, refer to SCC-101 manual.)
Notes
* RS-485 Communication establishment initial value
485 Control Board Connection Port RS-485 Control Port
(+)CONNECTIONTERMINAL WHITE(TRX+)
(-)CONNECTIONTERMINAL BLACK(TRX-)
Item
Camera ID BAUD RATE UART MODE RET PKT
Initial value
1 9600 8-NONE-1 ENABLE
(2)ConnectiontoaDVRorSystemController.
Connect the RS-485 cable to the connection ports of the DVR or System Controller.
•CoaxialCommunicationsSystem
•OSDControlmethod
DVR
Using Coaxial Communications
CAMERA DVR CONTROLLER
SET IRISOPEN IRISOPEN
UP JOYSTICK UP JOYSTICK UP
DOWN JOYSTICKDOWN JOYSTICKDOWN
LEFT JOYSTICKLEFT JOYSTICKLEFT
RIGHT JOYSTICKRIGHT JOYSTICKRIGHT
Distance Recommended Cable Specification
300m 3C2V(RG-59/U)
450m 5C2V(RG-6/U)
600m 7C2V(RG-11/U)
– Video Cable
 Thecamera'svideooutputportisconnectedtothemonitorwithaBNCcoaxialcable,
shown below : If the distance between the camera and the monitor exceeds the
recommended maximum, please use an auxiliary video amp.
• If the camera is controlled through coaxial communication, please use a video amp intended
for coaxial communications. Regular video amps do not transfer coaxial signals.
Notes
WHITE (TRX+) BLACK (TRX
-
)
DVD