setup screen
68_ setup screen
NETWORK SETUP
To set the video transfer mode
You can control the transfer rate according to the video transfer mode and network speed.
Select <Network> - <Streaming type>.
The Video Transfer setup window
appears.
When done, click [Apply].
Your settings will be saved.
VNP streaming : You can set the
Samsung Protocol (VNP) for the streaming service.
Protocol : Select a video transfer protocol from TCP*, UDP (Unicast)*, and UDP
(Multicast)*.
Speaking to the camera unit through microphone is not supported.
Multicast backbone (MBone) is not supported; you can access the camera only in the
multicast local network environment.
RTP streaming : You can set the RTP Protocol or the streaming service.
Protocol : Select a video transfer protocol from UDP (Unicast) and UDP (Multicast).
To set the DDNS
DDNS is an abbreviation of Dynamic Domain Name Service that converts the IP address
of a camera into a general Host Name so that the user can easily remember it and enables
connecting a camera with a fixed Host Name even if the IP address of the camera may be
dynamically changed.
Select <Network> - <DDNS>.
The DDNS setup window appears.
When done, click [Apply].
Your settings will be saved.
For checking the DDNS address, refer to
"To check the DDNS address".
(page 43)
1.
2.
y
-
y
-
1.
2.
M
To Next Page
Loading...
