setup screen
96_ setup screen
WDR Setup
You can set to display a sharp image of the objects in a scene where both bright and dark
areas exist.
1. Select <Back light>.
2. Set <Mode> to <WDR>.
3. Select each item and set it properly.
• WDR level : Specify the WDR
sensitivity level.
M
`
If WDR mode is active, the shutter mode cannot be changed. Data transfer via the network is
available at up to 15 fps.
`
If the WDR mode is active, a moving object can cause an afterimage on the screen.
Ex)
J
`
If you select WDR, you may encounter the following problems. So set it to Not Used.
-
Unnatural change of colors that cause an unnatural image on the screen
-
Noise on the bright area of the image
`
As the performance of the WDR function may differ depending on the bright-area size of the
image, it is recommended to optimize the installation angle for the best performance.
`
At night operation, this function will be activated only if the incoming highlight exceeds a certain
area in a low contrast environment.
`
Increasing the maximum value may cause an unnatural portion of the image.
<WDR OFF> <WDR ON>
To Next Page
Loading...
