Why does no image appear on my Samsung SNV-5080?
If no image appears, and the transmission method is set to multicast, verify that there is a router that supports multicast in the LAN to which the camera is connected.
What to do if images overlap on my Samsung SNV-5080 Security Camera?
If images overlap, check if two or more cameras are set to a single multicast address instead of different addresses. Using a single address for multiple cameras can cause overlapping images.
Why is my Samsung SNV-5080 Security Camera connected to the network not detected in the IP installer program?
If the camera is not detected in the IP installer program, try turning off the firewall settings on your PC and then search for the camera again.
What to do if my Samsung Security Camera viewer got disconnected during monitoring?
If the viewer disconnects during monitoring, it may be due to changes in camera or network configurations. Check all network connections. If the camera is connected over a PPPoE network, poor network conditions may also cause disconnections.
Why I can’t access my Samsung Security Camera from a web browser?
If you cannot access the camera from a web browser, verify the camera’s Network settings are correct. Also, check that all network cables are properly connected. If using DHCP, ensure the camera can obtain dynamic IP addresses. For DDNS, confirm the MAC address is correctly entered. If the camera is connected to a router, check that port forwarding is properly configured.
General| Brand | Samsung |
|---|---|
| Model | SNV-5080 |
| Category | Security Camera |
| Language | English |
To Next Page
