English _13
● OVERVIEW
Inside
Item Description
Monitor Out
Using the test monitor cable, you can connect to a mobile display for camera
test. (for installation)
b
Reset Button
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
c
SD Memory Card
Compartment
Compartment for the SD memory card.
IR LED These infrared LED's are controlled by the illumination sensor.
Illumination Sensor Detects incoming light to control the IR LED.
3
4
5
To Next Page
Loading...
