Samsung SNZ-5200 - Connecting with Other Device; Ethernet Connection; Power Supply

installation & connection
16_ installation & connection
CONNECTING WITH OTHER DEVICE
J
`
The BNC Out terminal of the product is provided for easier installation, and is not recommended
for monitoring purposes.
If you keep the BNC cable connected, a risk of lightening may cause damage or malfunction to
the product.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
`
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
`
If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.
`
Please make sure the monitor and camera are turned off when connecting them.
AUDIO OUT
VIDEO
SD SYSTEM POWER
RESET
NETWORK
ACT
LINK
GND
DC 12V
AUDIO IN
1 2 3 4 5 6
1 : ALARM OUT 4 : GND
2 : ALARM IN 5 : RS-485+
6 : RS-485-
3 : ALARM COM
SD CARDSD CARD
SD CARD
+
Monitor
Ethernet
Power