Samsung SNZ-5200 - Alarm Input

English _71
● SETUP SCREEN
Alarm input
You can set the alarm input type, activation time, and operation mode.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Alarm input>.
3. Specify an input device.
• Type
- Normal Open : It is normally open,
but if it is closed, an alarm will be
triggered.
- Normal Close : It is normally
closed, but if it is open, an alarm
will be triggered.
4. Specify the <Activation time>.
• Always : Always check if an alarm occurs. It activates in operated mode when the
alarm occurs.
`
If set to <Always>, the activation time cannot be changed.
• Only scheduled time : Check if an alarm occurs at a specified day of the week for
a specified time period. It activates in operated mode when the alarm occurs.
• [
] : All settings are released.
5. Specify an operation that will perform if an alarm occurs.
• Alarm output : Select whether to set the alarm output if an alarm is incoming, and
specify the alarm output time.
• E-mail sending : Specify the use of email transfer in the alarm input setup.
`
Refer to “FTP / E-mail” for more details. (page 68)
• FTP sending : Specify the use of FTP transfer in the alarm input setup.
`
Refer to “FTP / E-mail” for more details. (page 68)
• Record : This sets the option to record the content in the Micro SD memory card
when the alarm is input.
`
Set <Record> to <On> in <SD record>. (page 69)
• Goto Preset : Moves to the specified preset location when setting the alarm input.
`
Only if the camera pan/tilt receiver is installed, Goto Preset is available.
6. When done, click [Apply
( ) ].