Samsung SNZ-5200 - Page 70

setup screen
70_ setup screen
To make recording on the Micro SD memory
1. Check the <Total size> and the <Free size>.
2. If the Micro SD memory has a sufficient free space, set <Record> to <On>.
Otherwise, check the stored data and if you find them not important, then click
<Format> to format the Micro SD memory.
`
If your Micro SD memory card writes slowly, only one frame per second will be stored.
`
For a Micro SD memory card with a large capacity, the formatting will be slowed down accordingly.
`
Setting to higher options of resolution, bit rate and frame rate increases the amount of data produced.
As the size of data grows, transferred video can be stored only at 1 fps even if you set the record
quality to full frames.
`
As some space of the Micro SD memory card is reserved for the system, only about 90% of the total
capacity is available for use.
3. Specify the record conditions.
• Record profile : Display the number of profile to record.
• Overwrite : If the Micro SD memory is full, this will delete old data and store new
data in replacement.
• Pre-alarm duration : Set the image transfer time before the alarm. You can specify
up to 5 seconds before the occurrence of the alarm.
• Post-alarm duration : Set the image transfer time after the alarm. You can specify
up to 120 seconds after the occurrence of the alarm.
• Normal : This sets the option to always record the content regardless of the event.
- I-Frame : Records one image per second.
- Full : Records at the frame rate set in the record profile.
• Event : Set the recording type for a certain event that occurs.
`
<Event> recordings are not saved as <Normal>.
`
<Full> can be set when the <Normal> and <Event> recording resolution is 800x600 or less.
4. Specify the <Activation time>.
• Always : This is always recorded to the Micro SD memory card.
`
If set to Always, the activation time cannot be changed.
• Only scheduled time : This is recorded only during the specified time of the
specified day of the week.
• [
] : The specified time is released.
5. When done, click [Apply (
)].