setup screen
72_ setup screen
VA / MD
This can be set to generate an event signal when a motion or intelligent video analysis event
is detected.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <VA / MD>.
J
`
DIS cannot be used if VA/MD is used.
`
To use Motion detection (MD)
1. Select a motion detection mode.
2. Set <Motion Detection function> to
<Enable>.
3. Select a sensitivity level of the motion
detection.
Higher the sensitivity is, the smaller
motion is detected.
4. Use the drag-and-drop method to
specify the detection area on the video.
5. Specify the activation time and
activation condition.
`
For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 71)
6. When done, click [Apply
( )
].
J
`
If you are controlling the Pan/Tilt/Zoom operation or fitting the focus of the camera, the motion
sensor may not work.
To Next Page
Loading...
