Samsung SNZ-5200 - Page 55

English _55
● SETUP SCREEN
Exposure Setup
You can adjust the exposure level of the camera.
1. Select <Exposure>.
2. Select each item and set it properly.
• Brightness : Adjust the screen
brightness.
• Shutter mode : Adjust the electronic
shutter of the camera.
- ESC (Electronic shutter control)
: Adjust the shutter speed
automatically according to the
ambient brightness.
- Manual : Adjust the shutter speed of the camera manually.
- A.FLK (Anti flicker) : Select this feature if you encounter a flickering screen due
to a frequency mismatch with the ambient lighting.
`
Sens-up can be used only when the shutter type is <ESC>, and cannot be used when it is
<Manual> or <A.FLK>.
• Shutter speed : Control the shutter speed manually.
• SSNR3 : Specify the use of noise reduction.
`
SSNR3 mode cannot be used if the AGC mode is set to <Off> or <Manual>.
• SSNR3 level : Adjust the noise reduction level.
• Sens-up mode : Automatically senses the darkness level at night or in a low
contrast scene and extends the accumulation time accordingly for a bright and
sharp image.
`
Sens-up can be used only when the shutter type is <ESC>.
`
Sens-up mode cannot be used if the AGC mode is set to <Off> or <Manual>.
`
The greater the video accumulation factor is, the brighter the screen is but the afterimage of a
moving object grows accordingly and the Auto Focus mode may not operate properly.
`
If the gain is not used, Sens-up will be disabled.