Samsung SNZ-5200 - Page 57

English _57
● SETUP SCREEN
• Dwell time : This is the time while each applicable lighting condition is kept in
order to enable the switch between day and night modes.
• Duration : Specify the time interval of lighting at which the sequence operation is
triggered.
• Sharpness mode : Adjust the overall sharpness of the image.
If selecting <On>, you can adjust the sharpness of the image.
• Sharpness level : The higher the level is, the sharper and clearer the outline of the
image becomes.
• Gamma : Adjust the contrast of the image.
• Color level : Adjust the color level of the image.
Focus Setup
1. Select <Focus>.
2. Select each item and set it properly.
• Mode
- Manual : The focus will be adjusted
manually according to the zoom
factor.
- Auto : The focus will be adjusted
automatically according to the
zoom factor.
- One push af : Auto Focus will be performed once after the zooming operation.
• Digital zoom : Specify the use of digital zoom.
`
Digital zoom cannot be used if DIS is used.
• Digital zoom limit : Specify the limit of the digital zoom.
• Zoom tracking : Specify the focus sync mode with the panning/tilting/zooming
operation.
- Off : Only the zoom lens will work.
- Auto-Track : It will control (detect and correct) the zooming operation to keep
fitting the focus.
- Tracking : The zooming operation will be guided by the focus track.
• Zoom speed : Adjust the zoom tracking speed.
• Init. lens : Reset the lens to prevent the step-out in zoom mode.
• Duration : Specify the frequency of resetting the lens.
`
You can specify the date of resetting the lens that will perform in auto focus mode. Specify the time
between 1 and 7 days, and the resetting will be performed at 24-hour interval starting from the
specified date.