setup screen
64_ setup screen
IP filtering
You can create a list of IPs that you want to grant or deny access to them.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <IP filtering>.
3. Select <Filtering type>.
• Deny : If selecting this, access from
those IPs that are added to the
filtering will be restricted.
• Allow : If selecting this, access from
only those IPs that are added to the
filtering will be accepted.
4. Provide the IP that you want to grant or
deny access from.
When you enter an IP address and a
Prefix, the list of IP addresses available
will appear in the right-side filter range column.
M
`
If selected <Allow> for IP Filtering and <IPv6 setup> of <Interface> is set to <Use>, both IPv4
and IPv6 addresses of the computer currently configuring should be assigned.
`
The IP address of the computer used for the current setup cannot be added to <Deny>, it should
be added to <Allow>.
`
Only the IP addresses that are set to <Use> will be displayed in the filter column.
5. When done, click [Apply
( )
].
To Next Page
Loading...
