Operating Your Camera
2. Select a desired function using the Function Setup switch.
•Placethecursoroveradesireditem.
3. Set up a selected item by using the Function Setup switch.
4. To finish the setting, select ‘EXIT’ and press the Function Setup switch.
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
4.SSDR
OFF
5.BACKLIGHT OFF
6.SSNR3 ON
7.DAY/NIGHT AUTO
8.SPECIAL
9.EXIT SAVE
Select the function using
the Function Setup switch.
Change the status using
the Function Setup switch.
• An item with the icon also has sub menus. To select a sub menu, select an item with
the icon and press the Function Setup switch.
• An item with the - - - icon is unavailable due to function settings.
Notes
1. Press the Function Setup switch.
•Mainsetupmenuisdisplayedonthemonitorscreen.
Using this function, you can control the screen brightness.
1. When the SETUP menu screen is displayed, selectLENSby using the Function
Setup switch so that the arrow indicatesLENS.
LENS
MAIN SETUP
1.LENS DC
2.EXPOSURE
You can adjust the minimum shutter and maximum value of ESC shutter mode.
2. The Lens mode has sub menu site as listed below.
- BRIGHTNESS : Adjusts the video brightness.
- FOCUS ADJ : To adjust the DC lens focus correctly, you must activate the Focus
Settings mode. To a Activate the Focus Settings mode, adjust the lens
focus, and then deactivate the settings mode.
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
EXPOSURE
1. When the SETUP menu screen is displayed, select 'EXPOSURE’ by using the Function
Setup switch so that the arrow indicates 'EXPOSURE’.
2. Select a desired mode using the Function Setup switch.
EXPOSURE SETUP
1.BRIGHTNESS 25
2.SHUTTER ---
3.AGC HIGH
4.SENS-UP OFF
5.RETURN
SHUTTER : You can select the shutter.
- --- : Shutter speed is fixed at 1/60sec(1/50sec).
- ESC : Select this to control the shutter speed automatically. If ESC is selected,
the shutter speed is automatically controlled depending on the ambient
illumination of the subject.
- MANUAL :
You can control shutter speed manually.
(NTSC MODEL : 1/60sec~1/120,000sec, PAL MODEL : 1/50sec~1/120,000sec)
- A.FLK : Select this when you experience picture flicker, this happen when there
is a clash with the installed lighting frequency.