Samsung SUD-2080 - Installation Guide

COLOR DOME CAMERA User Guide
10
COLOR DOME CAMERA User Guide
11
Installation
Installation
PanBracket: Control panning angle of camera.
RotateBody: Control rotating angle of camera.
x3.6Vari-focalLensModule:2.8 ~ 10.0mm(F1.2).
VideoOutputTerminaltoMonitor
Function Setupswitch: Display the menu on the screen and move the cursor to four
directions to confirm status or after changing a selected item.
 UTPCable:For supplying AC 24V / AC28V power to the camera and transmitting video
signals.
VideoOutputJack:Video signals are output through this port. Connect this port to the
Video IN port of a monitor.
Powerinputterminal: If the UTP cable cannot be connected for power supply (distance
over 300m(1000ft), for example), this cable is used instead for connecting DC 12V / AC
24V power to the camera.
DomeCover
ShieldCase
Overview
1) Separate the dome cover by rotating anti-clockwise.
2) Separate the shield case by pulling from the camera body.
•Theinstallationshouldbedonebyqualifiedservicepersonnelorsyteminstallers.
•Iftheceilingmaterialisnotstrongenoughtoholdtheinstallationscrews,thecamera
mayfalloff.Reinforcetheceilingasneeded.
Notes
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Locking direction
(Clockwise)
Latch
Locking direction
[Figure 1]
Main Body
(Camera)
Shield Case
Dome cover
Unlocking direction
(Anti-clockwise)