Samsung U24E590D

75
Setup and Reset
6
6 Setup and Reset
6.5 DisplayPort Ver.
Select your Displayport. Displayport 1.1 supports High Bit Rate 1, while 1.2 supports High Bit Rate 2.
 Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
 If the monitor (when set to HDMI 1, HDMI 2 or DisplayPort) is in power saving mode or is
displaying the message Check Signal Cable, press the [ ] button to display the On Screen
Display (OSD). You can select 1.1 or 1.2.
 If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the
limitations in HBR1 transmission speeds.
6.5.1 Configuring DisplayPort Ver.
1 When the Function Key Guide appears, select [ ] by moving the JOG button UP.
Next, press the JOG button.
2 Move to System controlling the JOG button UP/DOWN and press the JOG button.
3 Move to DisplayPort Ver. controlling the JOG button UP/DOWN and press the JOG button.
The following screen will appear.
 1.1 / 1.2
4 Move to the desired option controlling the JOG button UP/DOWN and press the JOG button.
5 The selected option will be applied.
Off
Off
Auto
Select your
Displayport.
Displayport 1.1
supports HBR 1,
while 1.2 supports
HBR 2.
FreeSync
Eco Saving Plus
Off Timer
PC/AV Mode
DisplayPort Ver.
Source Detection
Key Repeat Time
System
Return
1.1
1.2