Samsung UH46F5

68
DST
Switches the DST (Daylight Saving Time) function on or off.
Off / On
• Start Date: Set the start date of Daylight Saving Time.
• End Date: Set the end date of Daylight Saving Time.
• Time Offset: Select the correct time offset your timezone.
Sleep Timer
Automatically shuts off the product after a preset period of time.
(Off / 30 min. / 60 min. / 90 min. / 120 min. / 150 min. / 180 min.)
―
Use the up and down arrows to select a period of time, and then press E. To cancel Sleep
Timer, select Off.
Power On Delay
When connecting multiple products, adjust the power-on time for each product to prevent
power overload (within the range 0–50 seconds).
MagicInfo I Source
MENU m → System → MagicInfo I Source → ENTER E
―
The MagicInfo I Source feature is available if a network box (sold separately) is connected.
Pressing MagicInfo Player I on the remote control displays content connected to the network
box (sold separately).
• DVI / DisplayPort
Auto Source Switching
MENU m → System → Auto Source Switching → ENTER E
Turning on the display with Auto Source Switching On, and the previous video source selection
is not active, the display will automatically search the different video input sources for active
video.
Auto Source Switching
When the Auto Source Switching is On, the display video source will automatically be searched
for active video.
The Primary Source selection will be activated, if the current video source is not recognised.
Secondary Source selection will become active, if no primary video source is available.
If both the primary and secondary input sources are not recognised, the display will perform
two searches for an active source, each search checking the primary and then secondary
source. If both searches fail, the display will return to the first video source and display a
message indicating that there is no signal.
When the Primary Source selection is set to All, the display will search all the video source
inputs twice in sequence looking for an active video source, returning back to the first video
source in the sequence if no video is found.
Primary Source Recovery
Select whether to restore the selected primary input source when a primary input source is
connected.
―
The Primary Source Recovery function is disabled if Primary Source is set to All.