EasyManua.ls Logo

Samsung WA400 Series - Key Features of Your Washer; Core Washing Features; Advanced Washer Features

Samsung WA400 Series
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ALIGNMENT AND ADJUSTMENTS
2
GENERAL ERROR FUNCTION
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
1
Thewaterlevelfailstodropbelow
theResetWaterLevelwithin30
minutes.
Goto“WillNotDrain
TroubleshootingSection.
2
DoorfailstoUnlockAfter7attempts.
Goto“WillNotUnlock
TroubleshootingSection.
3
(WA456*/WA422*/WA400*)
WhenthellingContinuesfor
morethan60minutesorthereisno
changeofwaterlevelfor5minutes.
Goto“NoWaterFill”
TroubleshootingSection.
4
Doorfailstolockafter7attempts.
Goto“WillNotLock”
TroubleshootingSection.
5
AwaterlevellowerthantheReset
waterlevelisdetectedfor5seconds
duringtheWash/Rinsecycle.
Goto“NoWaterFillTroubleshooting
Section.
6
WaterLevelSensorTrouble.(When
theinputsignalfromthewaterlevel
sensorisoutofrange,theunitwill
sendoutbeepingsoundsandhalts
thecycle.)
Goto“NoWaterFill”
TroubleshootingSection
7
Afaultisdetectedinthewaterlevel
sensor.Data(frequency)shows
thewaterlevelisatorabovethe
overowwaterlevel.(Whenthis
conditionisdetected,themachine
willautomaticallystartsdraining
wateruntilthewaterlevelfalls
belowtheresetwaterlevel)
Firstchecktoseethatallofwater
valvesarenotstuck.Ifwatervalves
areOK,checkwaterlevel.
8
Unbalanceorcabinetbumpis
detectedduringnalspin
GotoWetClothes”Troubleshooting
Section.
9
Doorisdetectedasopenwhileitis
tryingtolockthedoor.
Goto“QuickTestMode”andthendo
DoorLock/UnlockTest
10
Thisoccurswhenthewater
temperaturesensorfaultisdetected
continuouslyfor5seconds.
Goto“BoardInputTestandcheck
WaterTemperature.Checkloose
orpinchedwires.ReplacePCBor
thermistor.
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
TECH MANUAL_DC68-03132A-03_EN.indd 2 2013-5-27 9:46:18

Other manuals for Samsung WA400 Series

Related product manuals