Samsung WA400 Series - Safety Information; General Safety Instructions; Safety Symbols and Precautions

ALIGNMENT AND ADJUSTMENTS
3
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
11
MICOMisattemptingtodrivethemotor
butisnotgettinganyresponsesignals
fromthehallsensor.Visualcheckshows
motorisnotrunning.(Locked,Defective
HallSensororOverload)
Evaluatewireharnessforlooseor
unhookedconnections.Goto“
QuickTestMode”andtestMotor.
12
(WA422*/WA400*)
Thehot/coldwaterhoseconnection
isnotcorrect.
Pleaseconnectthehot/coldwater
hoseconnectioncorrectly.
(WA456*)
13
Sudsisdetectedduringthewashing
session.(“SUd”or“Sd”isnotanerror.
Whenitnisheswashing,Endand
the“SUd”or“Sd”codewillblinkin
turn.)
Guideausertoreduceamountof
detergentusage.
14
CommunicationerrorbetweenSUB
PBAandMAINPBA
CheckMainPBA,SUBPBA&Wire-
harness.ReplacePCB
15
IftheMEMScommunicationerroror
MEMStroublediagnosiserroroccur,
thismessagewillbedisplayed.
1.ChecktheMEMSsensorandPBA.
2.Checkthewireconnector
terminals
16
AbuttonexceptthePowerbuttonis
continuallypressed.
CheckwhethereitherthePower
switchoratactswitchiscontinually
pressed
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
TECH MANUAL_DC68-03132A-03_EN.indd 3 2013-5-27 9:46:20