Why does my Samsung WA400 have no water or not enough water?
If your Samsung Washer isn't filling properly, fully turn on both faucets and straighten the water inlet hoses. Also, disconnect the hoses and clean the screens, as hose filter screens may be clogged.
How to reduce vibration and noise in my Samsung WA400 Washer?
To reduce vibration or noise in your Samsung Washer, ensure it is set on a level surface and not touching any other object. Make sure the laundry load is balanced.
Why is my laundry load still too wet after the Samsung WA400 Washer cycle?
If your laundry load is too wet at the end of the Samsung Washer cycle, use the High spin speed and high efficiency detergent to reduce over-sudsing. Very small loads (one or two items) may become unbalanced and not spin out completely.
What to do if my Samsung WA400 Washer tried to fill but was unsuccessful?
If your Samsung Washer tried to fill but was unsuccessful, make sure the water faucets are open all the way. Check for kinked hoses and the inlet screens on the fill hoses. If you use a Flood Safety Device, remove it and connect the water hoses directly to the unit.
What should I do if my Samsung Washer is not draining?
If your Samsung Washer is not draining, turn the unit off and on again. Select only the Spin Cycle. Press the Start/Pause to drain the water. If it still does not drain, call for service.
What to do if my Samsung Washer shows a Door Error?
If your Samsung Washer displays a Door Error, the water level sensor terminal might be out of place. Inspect the MEMS sensor and PBA, and also check the wire connector terminals.
Details on Large Capacity, AquaJet™, Digital Inverter Motor, Mist Shower, and VRT® technologies.
Explanation of Eco Plus, Pure Cycle™, My Cycle, and Smart Care functionalities.
Essential guidelines and precautions for safe operation.
Explanation of warning symbols and their meanings for user safety.
Steps for unpacking the washer and identifying its main parts.
Guidelines for selecting a proper location and necessary electrical/water requirements.
Details on drain facility, flooring, location clearances, and dimensions.
Instructions for connecting water supply hoses and the drain hose.
Steps for leveling the washer and running the calibration mode.
Guidance on loading laundry and initiating the wash cycle.
Explanation of the washer's control panel layout and indicators.
Details on Child Lock, My Cycle, and Delay Start features.
Description of various wash cycles, pre-soak, AquaJet™, Eco Plus, and Smart Care.
Guidance on using detergents, bleach, and fabric softener with the dispenser.
Instructions for cleaning the external surfaces and the internal drum.
Procedures for cleaning the detergent dispenser and using the Pure Cycle™.
Troubleshooting common issues like no start, no water, or noise.
Understanding diagnostic codes displayed by the washer.
Reference charts for fabric care symbols and wash cycle settings.
Details on limited warranty coverage for U.S.A. and Canada.
To Next Page
General