Disassembly and Reassembly_31
No. Part name Description Figure
13 DD
MOTOR
1. To remove the hall sensor,
unfasten the 2 screws holding
both the stator and hall sen-
sor in place.
2. Remove the hall sensor by
exerting some force to the ▲
part.
√ Check Points for Troubleshooting
● A “3E” error occurs when the tub is driven in a wash or rinse cycle
but there is no problem with the stator.
→ Replace the hall sensor.
ROTOR
STATOR
HALL SENSOR REMOVED
To Next Page
Loading...
