Samsung WD906U4SA Series - Page 18

18_ setting up your washing machine
setting up your washing
machine
Connecting the water supply hose
1. Removetheadaptorfromthewatersupplyhose.
2. First, using a ‘+’ type screwdriver, loosen the four screws
ontheadaptor.Next,taketheadaptorandturnpart(2)
following the arrow until there is a 5 mm gap.
3. Connecttheadaptortothewatertapbytighteningthe
screws firmly while lifting the adaptor upwards.
Turnpart(2)followingthearrowandconnect(1)and(2).
4. Connectthewatersupplyhosetotheadaptor.
Whenyoureleasepart(3),thehoseautomatically
connects to the adaptor making a ‘click’ sound.
After you have connected the water supply
hose to the adaptor, ensure that it is connected
correctly by pulling the water supply hose
downwards.
5. Connecttheotherendofthewatersupplyhosetotheinlet
water valve at the rear of the washing machine. Screw the
hose clockwise all the way in.



1
2

1
2


3
WD906U4SAGD-03223L_EN(EU).indd 18 2013-3-29 12:02:17