Samsung WD906U4SA Series - Connecting the Water Supply Hose

setting up your washing machine _17
01 setting up
STEP 3

Wheninstallingyourwashingmachine,ensurethatthepowerplug,thewatersupplyand
the drain are easily accessible.
1. Slide the washing machine into position.
2. Levelyourwashing
machine by turning the
levelling feet in and out as
necessary by hand.
3. Whenyourwashingmachineislevel,tightenthenutsusing
the wrench supplied with your washing machine.
STEP 4

Connecting the water supply hose
1. TaketheL-shapedarmttingforthecoldwater
supply hose and connect it to the cold water
supply intake on the back of the machine.
Tighten by hand.
The water supply hose must be connected to
the washing machine at one end and to the
watertapattheother.Donotstretchthewater
supplyhose.Ifthehoseistooshort,replace
the hose with a longer, high pressure hose.
2. Connecttheotherendofthecoldwatersupply
hose to your sink’s cold water tap and tighten
itbyhand.Ifnecessary,youcanrepositionthe
water supply hose at the washing machine end
by loosening the fitting, rotating the hose, and
retightening the fitting.

1. TaketheredL-shapedarmttingforthehotwatersupplyhoseandconnectittothehot
water supply intake on the back of the machine. Tighten by hand.
2. Connecttheotherendofthehotwatersupplyhosetoyoursink’shotwatertapandtighten
it by hand.
3. Use a Y-piece if you only want to use cold water.

WD906U4SAGD-03223L_EN(EU).indd 17 2013-3-29 12:02:16