EasyManua.ls Logo

Samsung WD906U4SA Series - Washing a Load of Laundry; Initial Wash and Basic Loading

Samsung WD906U4SA Series
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
washing a load of laundry _21
02 Washing a load of laundry
washing a load of laundry
With your new Samsung washing machine, the hardest part of doing laundry will be
deciding which load to wash first.

Beforewashinglaundryforthersttime,youmustrunacompleteemptycycle(i.e.nolaundry).
1. Press the Power button.
2. Add a little detergent to the detergent compartment
in
the detergent drawer.
3. Turn on the water supply to the washing machine.
4. Press the Start/Pause button.
This will remove any water that might be left over in the
machine from the manufacturer’s test run.
 :Detergentforprewash,orstarch.
 :Detergentforthemainwash,watersoftener,pre-soakingagent,bleachand
stain removal product.
Touseliquiddetergent,usetheliquiddetergentbox(refertopage33ofthemanualforthe
correspondingmodel).Donotaddpowdereddetergentintotheliquiddetergentbox.

:Additives,e.g.fabricsoftenerorformer(llnohigherthanloweredge(MAX)
of“A”)

1. Loadyourlaundryintothewashingmachine.
Donotoverloadthewashingmachine.Todeterminetheloadcapacityforeachtypeof
laundry,refertothechartonpage31-32.
• Makesurethatlaundryisnotcaughtinthedoor,asthismaycauseawaterleak.
• Washingdetergentmayremaininthefrontrubberpartofthewasherafterawashcycle.
Removeanyremainingdetergent,astheymaycauseawaterleak.
• Donottouchthedoorglasswhileyourwashingmachineisrunningoritmaybehot.
• Donotopenthedetergentdrawerorthedebrislterwhileyourwashingmachineis
running or you might be exposed to hot water or steam.
• Donotwashwater-proofeditemsinnormalcycleexceptoutdoorcareprogram.
2. Closethedooruntilitlatches.
3. Turn the power on.
4. Add detergent and additives to the dispenser drawer.
5. Select the appropriate cycle and options for the load.
TheWashIndicatorlightwillilluminateandtheestimatedcycletimewillappearinthedisplay.
6. Press the Start/Pause button.

WD906U4SAGD-03223L_EN(EU).indd 21 2013-3-29 12:02:18

Related product manuals