Samsung WD906U4SA Series - Initial Test Run

20_ setting up your washing machine
setting up your washing
machine
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
1. Over the edge of a wash basin:Thedrainhosemustbeplacedataheightofbetween60
and90cm.Tokeepthedrainhosespoutbent,usethesuppliedplastichoseguide.Secure
the guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose
from moving.
2. ln a sink drain pipe branch: The drain pipe branch must be above the sink siphon so that
theendofthehoseisatleast60cmabovetheground.
3. ln a drain pipe:Werecommendusinga65cmhighverticalpipe;itmustbenoshorterthan
60cmandnolongerthan90cm.
The standpipe drain requires;
• minimumdiameter5cm.
• minimumcarry-awaycapacity60literperminute.
STEP 5

Plugthepowercordintoawallsockets,anAC220V/50Hzapprovedelectricaloutletprotected
byafuseorcircuitbreaker.(Formoreinformationonelectricalandgroundingrequirements,see
page14.)

Make sure that you install your washing machine correctly by running the  cycle
after the installation is complete.


60~90cm
60~90cm
WD906U4SAGD-03223L_EN(EU).indd 20 2013-3-29 12:02:18