2 S&C Instruction Sheet 766-557
Qualified Persons
Ç
WARNING
The equipment covered by this publication must be installed, operated, and maintained by
qualified persons who are knowledgeable in the installation, operation, and maintenance
of overhead electric power distribution equipment along with the associated hazards. A
qualified person is one who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from non-live
parts of electrical equipment.
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed.
• The proper use of the special precautionary techniques, personal protective equip-
ment, insulating and shielding materials, and insulated tools for working on or near
exposed energized parts of electrical equipment.
These instructions are intended only for such qualified persons. They are not intended
to be a substitute for adequate training and experience in safety procedures for this type
of equipment.
Read this
Instruction Sheet
Thoroughly and carefully read this instruction sheet before programming, operating, or
maintaining your S&C IntelliRupter PulseCloser Fault Interrupter. Familiarize yourself
with the safety information on page 3. The latest version of this instruction sheet is avail-
able online in PDF format at sandc.com/Support/Product-Literature.asp
Retain this
Instruction Sheet
This instruction sheet is a permanent part of your S&C IntelliRupter PulseCloser Fault
Interrupter. Designate a location where you can easily retrieve and refer to this publication.
Special Warranty
Provisions
The standard warranty contained in S&C’s standard conditions of sale, as set forth in Price
Sheet 150, applies to IntelliRupter® fault interrupter and its associated options except
for the control group (the protection and control module and communication module)
and S&C SpeedNet™ Radio, as applicable. For these devices the rst paragraph of said
warranty is replaced by the following:
(1) General: Seller warrants to immediate purchaser or end user for a period of
10years from the date of shipment that the equipment delivered will be of the kind and
quality specified in the contract description and will be free of defects of workmanship
and material. Should any failure to conform to this warranty appear under proper and
normal use within ten years after the date of shipment the seller agrees, upon prompt
notification thereof and confirmation that the equipment has been stored, installed, oper-
ated, inspected, and maintained in accordance with recommendations of the seller and
standard industry practice, to correct the nonconformity either by repairing any dam-
aged or defective parts of the equipment or (at seller’s option) by shipment of necessary
replacement parts.
Replacement control groups and S&C SpeedNet Radios provided by seller or repairs
performed by seller under the warranty for the original equipment will be covered by
the above special warranty provision for its duration. Replacement control groups and
S&C SpeedNet Radios purchased separately will be covered by the above special war-
ranty provision.
This warranty does not apply to major components not of S&C manufacture, such
as batteries and communication devices, as well as hardware, software, resolution of
protocol-related matters, and notification of upgrades or fixes for those devices. However,
S&C will assign to immediate purchaser or end user all manufacturers’ warranties that
apply to such major components.
Introduction
To Next Page
Loading...
Need help?
General