22 S&C Instruction Sheet 766-557
NOTICE
Always turn off the docking station power switch before disconnecting the modules.
The docking station includes an inrush current limiter. It requires about 2 minutes to
reset after the power switch is turned off... power cannot be turned on during that time.
Step 1
Turn off the docking station power switch.
Step 2
Carefully disconnect the protection and control module and the communication module
from the docking station.
Step 3
If applicable, disconnect the directly connected computer and/or DNP test set.
Step 4
Disconnect the power cord from the docking station. Then unplug the power cord from
the ac outlet.
Shutting Down
To Next Page
Loading...
Need help?
General