12 S&C Instruction Sheet 681-530
Figure 3. Disconnect the trip connectors and the USB connector.
STEP 3. Loosen the four captive screws that secure the electronics module to the base
plate. See Figure 4.
Removing the Electronics Module for Service Center Programming
STEP 2. Loosen the screws holding the two trip connectors in place. Disconnect the trip
connectors and USB connector from the front of the electronics module. See
Figure 3.
Screws
(Not
Visible)
Screws
Trip
Connectors
USB
Connector
Figure 4. Loosen the four screws securing the electronics module to the base plate.
To Next Page
Loading...
