S&C Vista - Logging in for the First Time; Default Passwords; Changing the Admin Password

S&C Instruction Sheet 681-530 21
Figure 15. Enter the default admin username and password.
NOTICE
DO NOT lose the admin password. For security reasons, there is no password-
retrieval system built in to the overcurrent control. If the admin password is lost, the
control must be returned to S&C Electric Company to restore access to the control.
The overcurrent control comes with two default passwords, one for the “admin” login
and one for the “user” login. (See the “User access and privileges” section on page 9 for
details on the access levels of the two logins.) S&C strongly recommends changing admin
and user login passwords from the default setting when  rst logging in to the control. You
will be prompted to change the user login password at the  rst login under this username.
The default passwords are:
Username Password
admin 4731
user 6601
NOTICE
After changing the password, S&C recommends logging in to the “admin” login
ONLY when directed to do so by S&C Electric Company. Use the “user” login when
general changes need to be made to the Overcurrent Control settings. Use the View
button for regular access to the overcurrent control.
To change the admin password:
STEP 1. At the Login screen, enter in the default admin username and password.
See Figure 15.
Logging In for the First Time
Changing the Admin
Password
Default Passwords