S&C Instruction Sheet 681-530 17
To connect to the overcurrent control :
STEP 1. Make sure the USB driver ha s been installed on the computer per the instr uctions
in the “Installing the USB Driver” section on page 10.
STEP 2. Remove the USB data-port cap. Plug the A-male end of a USB cable, no longer
than three meters, into the USB receptacle on the side of the overcurrent
control. See Figure 11. This cable should have a minimum conductor size of
24AWG. Plug the opposite end of the USB cable into an open USB receptacle on
the PC. Windows OS will detect the overcurrent control as a USB device.
STEP 3. When nished programming the overcurrent control, make sure to replace the
data-port cap.
NOTICE
Make sure the data-port cover is secure after programming the control.
Failure to secure the data-port cap may result in damage to the data port.
A control with a damaged data port cannot be accessed via personal
computer through the port.
Connecting to the Overcurrent Control
Connecting to the
Overcurrent Control
Using USB
Figure 11. Remove the data-port cap and plug a USB cable into the control. Plug the opposite
end of the cable into a PC.
USB cable
Cap
To Next Page
Loading...
