S&C Instruction Sheet 681-530 27
The Load Current menu shows a snapshot of the load current going through the two
fault interrupters or through ground. When the control is removed from its enclosure
for service center programming, the load current will be zero in all interrupting ways
and to ground.
The Control Settings menu shows the Overcurrent Protection settings for the control.
The overcurrent control settings cannot be edited on this menu.
The About menu shows the login status of the control, the control name, the MAC address
of the control, and the rmware version.
Load Current Menu
Control Settings Menu
About Menu
Understanding the Status Display
To Next Page
Loading...
