SanDisk SDP3B - 2 0 Product Specifications; SDP3 B Flashdisk System Environmental Specifications; SDP3 B Flashdisk System Power Requirements

SDP3B FlashDisk Product Manual
SanDisk SDP3B FlashDisk Product Manual © 1998 SANDISK CORPORATION14
2.0 Product Specifications
For all the following specifications, values are
defined at ambient temperature and nominal
supply voltage unless otherwise stated.
2.1 SDP3B FlashDisk System
Environmental Specifications
SDP3B
(Standard Version)
SDP3BI
(Industrial Version)
Temperature Operating:
Non-Operating:
0° C to 60° C
-25° C to 85° C
-40° to 85° C
-50° to 100° C
Humidity Operating:
Non-Operating:
8% to 95%, non-condensing
8% to 95%, non-condensing
8% to 95%, non-condensing
8% to 95%, non-condensing
Acoustic Noise: 0 dB 0 dB
Vibration Operating:
Non-Operating:
15 G peak to peak max.
15 G peak to peak max.
15 G peak to peak max.
15 G peak to peak max.
Shock Operating:
Non-Operating:
1,000 G max.
1,000 G max.
1,000 G max.
1,000 G max.
2.2 SDP3B FlashDisk System Power
Requirements
SDP3B
(Standard Version)
SDP3BI
(Industrial Version)
DC Input Voltage (VCC)
100 mV max. ripple (p-p)
3.3V ±5% 5V ± 10% 3.3V ±5% 5V ±5% Only
Capacities of
85 MB & Lower
+5 V Currents
(maximum Average value)
See Notes 1 to 3.
Sleep:
Reading:
Writing:
Read/Write Peak
200 µA
(Slow - Fast)
32 mA - 45 mA
32 mA - 60 mA
150 mA/50µs
500 µA
(Slow - Fast)
46 mA - 75 mA
46 mA - 90 mA
150 mA/50µs
200 µA
(Slow - Fast)
32 mA - 45 mA
32 mA - 60 mA
150 mA/50µs
500 µA
(Slow - Fast)
46 mA - 75 mA
46 mA - 90 mA
150 mA/50µs
Capacities
above 85 MB
Sleep:
Reading:
Writing:
Read/Write Peak
200 µA
(Slow - Fast)
32 mA - 50 mA
32 mA - 70 mA
150 mA/50µs
500 µA
(Slow - Fast)
46 mA - 90 mA
46 mA - 110 mA
150 mA/50µs
200 µA
(Slow - Fast)
32 mA - 50 mA
32 mA - 70 mA
150 mA/50µs
500 µA
(Slow - Fast)
46 mA - 90 mA
46 mA - 110 mA
150 mA/50µs
Note 1. All values quoted are typical at ambient temperature and nominal supply voltage unless otherwise stated.
Note 2. Sleep mode currently is specified under the condition that all card inputs are static CMOS levels and in a
“Not Busy” operating state.
Note 3. The currents specified show the bounds of programmability of the product.