SanDisk SDP3B - Standby - 96 H,E2 H; Standby Immediate - 94 H,E0 H

SDP3B FlashDisk Product Manual
SanDisk SDP3B FlashDisk Product Manual © 1998 SANDISK CORPORATION 73
6.1.20 Standby - 96H,E2H
Bit -> 7 6 5 4 3 2 1 0
Command (7) E2H or 96H
C/D/H (6) X Drive X
Cyl High (5) X
Cyl Low (4) X
Sec Num (3) X
Sec Cnt (2) X
Feature (1) X
This command causes the SDP3B FlashDisk to set
BSY, enter the Sleep mode (which corresponds to
the ATA “Standby” Mode), clear BSY and return
the interrupt immediately. Recovery from sleep
mode is accomplished by simply issuing another
command (a reset is not required).
6.1.21 Standby Immediate - 94H,E0H
Bit -> 7 6 5 4 3 2 1 0
Command (7) E0H or 94H
C/D/H (6) X Drive X
Cyl High (5) X
Cyl Low (4) X
Sec Num (3) X
Sec Cnt (2) X
Feature (1) X
This command causes the SDP3B FlashDisk to set
BSY, enter the Sleep mode (which corresponds to
the ATA “Standby” Mode), clear BSY and return
the interrupt immediately. Recovery from sleep
mode is accomplished by simply issuing another
command (a reset is not required).