SDP3B FlashDisk Product Manual
SanDisk SDP3B FlashDisk Product Manual © 1998 SANDISK CORPORATION8
1.3 System Features
• Up to 220 megabytes of data storage
available
• PC Card ATA protocol compatible
• True IDE Mode compatible
• Very low CMOS power
• Very high performance
• Programmable power versus performance
• Very rugged
• Low weight
• Noiseless
• Low Profile
• +5 Volts or +3.3 Volts operation
• Automatic error correction and retry
capabilities
• Supports power down commands and sleep
modes
• Non-volatile storage (no battery required)
• MTBF of 1,000,000 hours for Type II
FlashDisk, 500,000 hours for Type III
FlashDisk
• Minimum 10,000 insertions
• Standard (SDP3B) and industrial
(SDP3BI) versions available
1.4 PCMCIA Standard
SDP3B FlashDisks are fully compatible with the
PCMCIA specifications listed below. These
specifications may be obtained from:
PCMCIA
2635 N. First St. Suite 209
San Jose, CA 95134
USA
Phone: 408-433-2273
Fax: 408-433-9558
1) PCMCIA PC Card Standard, January 1995
2) PCMCIA PC Card ATA Specification,
January 1995
1.5 Related Documentation
1) American National Standard X3.221
AT Attachment for Interface for Disk
Drives Document
This document can be obtained by calling
Global Engineering at 1-800-854-7179.
1.6 The SDP3B FlashDisk Compared
to Previous FlashDisks
The SDP3B FlashDisk is compatible with
SanDisk’s previous FlashDisk products, the SDP,
SDP5, and the SDP5A product. The SDP3B
FlashDisk is not compatible with the SDP5L
which was designed specifically for the HP95LX.
Therefore, the SDP3B FlashDisk is not system
compatible with the HP95LX. For this document,
any of these products are defined as the SDP
Series products. Several improvements have been
added to the SDP3B FlashDisk that do not
appear in previous products. Differences between
the SDP3B FlashDisk and the previous
FlashDisks that could be noticed by previous
FlashDisk users are explained in the following
sections.
To Next Page
Loading...
