8
First Time Use
Initial Scan
When your radio is switched on from
Standby for the rst time it will scan the
DAB band, searching for usable stations.
These will be stored alphanumerically.
The initial scan will take a few minutes.
While the scan is running, the scan
progress will be shown on a bargraph
and the number of stations found will be
displayed.
Manual clock settings will be updated
when you next tune to a DAB station.
When the scan nishes, the radio will play
the rst station in the sequence.
Note: If no stations are found, switch the
radio o and move it to a location with a
stronger signal. When you switch the radio
back on it will automatically repeat the
scan process.
Setting the Clock
Automatically
The time and date are set automatically
from DAB station information.
Setting the Clock Manually
The clock can be set manually if there are
no DAB stations in your area.
Refer to the ‘Time’ section on page 23 for
more details.
Number of stations found
Scan progress
SDABXRL13_IB.indd 8 08/04/2013 10:30
To Next Page
Loading...
