Sandstrom SDABXRL13 User Manual

7
Mains Power
This unit is designed only to operate with
the supplied AC adapter.
Connecting the radio to any other power
source may damage it.
• Unwind the AC adapter cable to its full
length.
• Connect the plug at the end of the
cable to the DC IN Socket on the back
of the radio.
• Plug the AC adapter into a mains socket
and switch the socket on (if necessary).
The unit is now connected and ready to use.
• To switch the unit o completely,
unplug the mains adapter from the
mains socket.
Standby Control
When you  rst connect the radio to the
mains socket, the radio will be ON.
• Press (Standby) to switch the unit to
standby mode.
• Press
(Standby) again to switch the
unit on.
Disconnect the AC adapter from the mains
socket if you want to switch the unit o
completely.
Getting Started
Fitting Batteries
You can  t batteries (not supplied) to your
radio for portable operation.
• Press the battery cover catches
(arrowed).
• Lift o the battery cover.
• Fit 6 x AA batteries (not included) into
the battery compartment, observing
polarity as shown.
• Re- t the battery cover.
Dispose of used batteries with regard to
the recycling regulations in your area. Do
NOT short circuit batteries or throw them
into water, the general rubbish or in a  re.
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
When battery powered, the button
will function as a POWER ON/OFF button.
When switched o , the radio and display
will power o completely to conserve
battery power.
SDABXRL13_IB.indd 7 08/04/2013 10:30

Sandstrom SDABXRL13 Specifications

General

Brand	Sandstrom
Model	SDABXRL13
Category	Radio
Language	English