Sandstrom SL-DBTB18 - Alarm Function Details; Alarm Operation and Snooze; Activating;Deactivating Alarms

21
On time 00:00 (manually set up the time)
Source Buzzer / DAB / FM
(If the wake-up source is DAB / FM and the
signal strength is low, the Buzzer alarm will
be triggered.)
Preset Last listened or saved preset station (not
available for Buzzer mode)
Frequency Daily / Once / Weekends / Weekdays
Alarm volume Turn the –TUNE+ / SCROLL & SELECT dial to
select to adjust the alarm volume
Alarm On/OFF Turn the –TUNE+ / SCROLL & SELECT dial to
select to Alarm On/Alarm Off
If there is no DAB broadcast in your area, switch the unit into
FM mode to receive the time signal, or you may set the clock
manually (Refer to “Setting the Time and Date” section above).
3. After the setup is done, (Alarm 1), (Alarm 2) or (Alarm 1 and
Alarm 2)will show on the display.
4. To temporarily switch o alarm, press the SNOOZE button to activate
Snooze function when alarm sounds. Press the SNOOZE button
repeatedly to set snooze period time of 5, 10, 15 or 30 minutes in
turn. The set snooze time will show on the display and unit will go to
standby.
5. To turn o alarm, press the ALARM button when alarm sounds.
6. To cancel Alarm, refer to steps 1-4 to set Alarm O.
or icon will
disappear from display.
Activate/Deactivate the Alarm Function
These changes must be made with the unit in Standby mode.
1. To activate or deactivate the alarm function, press the ALARM button,
and then press the SCROLL & SELECT dial to select “Alarm 1: On“ or
“Alarm 1: O” and “Alarm 2: On“ or “Alarm 2: O”.
2. Press the SCROLL & SELECT dial to conrm.
SL-DBTB_C_G18_IB_Final190610V2.indd 21 10/06/2019 11:51